Jensen DV2011, Инструкция по установке и эксплуатации

Страница: 6 / 24

DV2011
6
3. Remove the factory mounting
brackets and hardware from the
existing radio and attach them
to the new radio. Select a
position where the screw holes
of the bracket and the screw
holes of the main unit are
aligned (are fitted). Tighten the
screws at 2 places on each
side. Do not exceed M5 x 9 MM
maximum screw size. Longer
screws may damage
components inside the chassis.
4. Wire the new radio to the
vehicle as outlined in the
Universal Installation instructions.
5. When wiring is complete, reconnect the battery negative terminal.
6. Mount the new radio assembly to the dashboard or center console using the reverse
procedure of step 1.
NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B
installation.
Removing the Unit (Method A Installation)
To remove the radio after installation:
1. Insert fingers into the groove in the front of
frame and pull out to remove the frame.
(When re-attaching the frame, point the side
with a groove downwards and re-attach.)
2. Insert the removal keys straight
back until they click, and then
pull the radio out. If removal keys
are inserted at an angle, they will
not lock properly to release the
unit.
Detachable Control Panel (DCP)
Removing the Detachable Control Panel (DCP)
1. Turn the power off.
2. Press the REL button.
3. Remove the DCP.
Attaching the DCP
1. Attach the panel at the right side first, with point B on the
main unit touching point A on the DCP (as shown in the
diagram).
2. Press the left side of the DCP onto the main unit until a
“click” is heard.
CAUTION:
• DO NOT insert the DCP from the left side. Doing so may damage it.
• The DCP can easily be damaged if dropped or subjected to a strong shock. When the
release button is pressed and the DCP is unlocked, the vehicle's vibrations may
cause it to fall. To prevent damage to the DCP, always store it in a protective case
after detaching it.
• The rear connector that connects the main unit and the DCP is an extremely important
part. Be careful not to damage it by pressing on it with fingernails, pens,
screwdrivers, etc.
• If the DCP is dirty, remove debris with a soft, dry cloth only. You can use a cotton
swab soaked in isopropyl alcohol to clean the socket on the back of the DCP.
Screws
Dashboard
Factory
Mounting
Bracket
Hook (Remove)
Dashboard
Removal Key
Sleeve
Removal Key
PANEL RELEASE
BUTTON
DV2 011 DV201 1
DIGI TAL AUD IO DIGI TAL AUD IO
COM P COMP ACT ACT
MP3 MP3
WMA WMA
MOD E MODE
MUT E MUTE
BAN
D
BAND
LOU
D
LOUD
LOC LOC
EQ EQ
1
2 3
4 5
6 A/PS A/PS
DISP DISP
INT INT RPT RPT
RDM RDM
AV IN AV IN
B
A
2
1