E-6
BATTERY NOTE AND CARE
1.
Danger of explosion if the battery is replaced incorrectly. Replace only with the
same or equivalent type
2.
Do not mix old and new batteries.
3.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
4.
If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and may void
the warranty.
5.
Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer’s directions).
6.
Do not dispose of batteries in fire, batteries may leak or explode.
Using an adaptor (not included) to power the unit
1.
Before connecting the adaptor to the player, make sure that the AC voltage of
the adaptor corresponds to you local AC outlet voltage. The polarity of the
adaptor must match to the polarity markings next to the DC jack on the player.
2.
Plug the 4.5V DC 700mA AC-DC adaptor into an AC outlet.
3.
Insert the DC plug into the DC IN jack on the player.
NOTE:
When the AC-DC adaptor is connected, the batteries will be automatically
disconnected and the player will now operate on the adaptors power. Once the
adaptor is unplugged the player will automatically switch to back to battery power.
EARBUDS CONNECTION
Connect the plug of the stereo earbuds (included) into the PHONES socket.
CAUTION
•
AVOID EXCESSIVE VOLUME LEVELS FOR LONG PERIODS OF TIME
WHEN USING THE HEADPHONES. PROLONGED USE AT HIGH LEVELS
MAY IMPAIR YOUR HEARING.
•
Do not use earbuds while operating a motorized vehicle, as it may create
a traffic hazard and is illegal in many areas
.
CD OPERATION
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all commercial CDs.
They will also read self-compiled CD-R/CD-RW discs but it may take up to 10 seconds
for playback to start. If playback does not start, it is likely due to the quality of the
CD-R/RW disc and/or the compatibility of the CD compilation software. Manufacturer is
not responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.