Apply sealant to 3 screws, fill coax hole, connect
coax to antenna and wrap connection with insulating
electrical tape. Coax connection should be located
inside vertical stalk of antenna for service.
6
7) Attach antenna to base and seal all seams and screws on plate and antenna base
8) Install interior plate using included hardware over hole in ceiling
9) Remove plate from wall and disconnect all wires and cables (note power/ground
polarity & cable labels)
10) Connect appropriate cables / wires and install new plate. Tape all coax connections
Refer to the ANHD20 Installation / Operation for additional
installation details
ASA ELECTRONICS CORPORATION
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 ASA Electronics Corporation
Remove plate from wall and disconnect all wires and
cables (note power/ground polarity & cable labels).
9
7) Attach antenna to base and seal all seams and screws on plate and antenna base
8) Install interior plate using included hardware over hole in ceiling
9) Remove plate from wall and disconnect all wires and cables (note power/ground
polarity & cable labels)
10) Connect appropriate cables / wires and install new plate. Tape all coax connections
Refer to the ANHD20 Installation / Operation for additional
installation details
ASA ELECTRONICS CORPORATION
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 ASA Electronics Corporation
Attach antenna to base and seal all seams and screws
on plate and antenna base.
7
7) Attach antenna to base and seal all seams and screws on plate and antenna base
8) Install interior plate using included hardware over hole in ceiling
9) Remove plate from wall and disconnect all wires and cables (note power/ground
polarity & cable labels)
10) Connect appropriate cables / wires and install new plate. Tape all coax connections
Refer to the ANHD20 Installation / Operation for additional
installation details
ASA ELECTRONICS CORPORATION
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 ASA Electronics Corporation
Connect appropriate cables / wires and install new
plate. Tape all coax connections.
10
Apply sealant to holes and attach base using the
included hardware.
5
7) Attach antenna to base and seal all seams and screws on plate and antenna base
8) Install interior plate using included hardware over hole in ceiling
9) Remove plate from wall and disconnect all wires and cables (note power/ground
polarity & cable labels)
10) Connect appropriate cables / wires and install new plate. Tape all coax connections
Refer to the ANHD20 Installation / Operation for additional
installation details
ASA ELECTRONICS CORPORATION
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 ASA Electronics Corporation
install interior plate using
included hardware over
hole in ceiling.
8
Refer to the ANHD20
installation/operation for
additional installation details.
AsA eLeCTRoNiCs CoRpoRATioN
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 AsA electronics Corporation
