8
3. Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the wine cellar.
Remove and Replace the Bottom Rack
1. Lift the rack (front and back) up and pull straight out to
remove.
2. Replace the rack by pushing it straight back and over the
stop. Continue pushing the rack evenly until it is in place.
Stocking the Wine Cellar
NOTE: For optimum wine storage, place white wines at the top of
the wine cellar, light red wines in the center and red wines at the
bottom.
To stock the wine cellar
1. Start stocking the wine cellar with the bottom display rack.
2. Starting on the left-hand side, place the first bottle on the
bottom of the rack with the neck of the bottle facing the front
of the wine cellar.
3. Place the next bottle on its side with the neck of the bottle
facing the back of the wine cellar. Alternate the direction of the
bottles, in this manner, until the display rack is full.
4. Slide the bottom rack into place and pull the next rack
forward.
5. Continue stocking each remaining rack as described in the
above steps.
Lighting the Wine Cellar
The wine cellar has an interior light that comes on any time the
door is opened. You may also choose to keep the light on at all
times by pressing the left side of the switch, located next to the
temperature control, on the base grille.
NOTES:
■
Leaving the light on for an extended period of time will slightly
increase the temperature of the wine cellar.
■
The light is an LED which does not need to be replaced. If the
LED does not illuminate when the door is opened, call Service
to replace the light. See Assistance or Service for contact
information.
WINE CELLAR CARE
Base Grille
You must remove the base grille to access the condenser coils for
cleaning.
To remove the base grille:
1. Open the wine cellar door.
2. Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the wine cellar.
3. Remove the base grille.
To replace the base grille:
1. Open the wine cellar door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
A. Tabs
B. Screws
B
A
A
