WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
20
16022882 Rev. 0
©2004 Maytag Services
Dual Feed Burner Base
NOTE:
Maintop needs to be removed for burner base
replacement.
1. Disconnect power and shut off gas supply to unit.
2. Remove maintop, see “Maintop” procedure.
3. Remove gas lines from burner base.
4. Remove screw securing ground wire, located at the
front of the burner hanger.
5. Remove screw securing front baffle to burner hanger.
6. Trace high voltage electrode wire to spark module and
disconnect.
7. Pull electrode wire through front baffle.
8. Remove dual feed burner base off of hanger, by
removing screws from the bottom of the hanger.
9. Reverse procedure to reassemble.
Broil Burner
NOTE:
Unit must be pulled away from the wall for this
procedure.
1. Disconnect power supply to unit.
2. Remove oven door, see “Oven Door” procedure.
3. Remove screws securing broiler ignitor bracket to the
back wall of the oven cavity.
4. Gently lower the ignitor down and let hang freely.
5. Remove gas line from venturi using a 5/16” wrench.
6. Remove screws securing broil burner to the oven
cavity top.
NOTE:
When removing burner, ensure the burner will not
fall or come down at an angle.
NOTE:
Use caution not to damage orifice elbow and
insulation.
Convection Fan / Capacitor
1. Disconnect power supply to unit.
2. Remove oven door, see “Oven Door” procedure.
3. Remove bake element, see “Bake Element”
procedure.
4. Remove screws securing convection baffle to rear of
oven cavity.
5. Remove screws securing convection fan to rear of oven
cavity.
NOTE:
When removing the last two screws, hold fan
assembly in place.
6. Gently lower fan and place on the oven bottom.
7. Disconnect and label wire terminals on fan.
NOTE:
When reinstalling, install screws into center
holes on convection fan to assist in aligning
corner holes.
8. Replacement of capacitor can be done two ways.
• Removal of convection fan.
• Accessing through the rear of the unit and removing
the rear motor housing.
9. Reverse procedure to reassemble.
Gas Train
1. Disconnect power and shut off gas supply to unit.
2. Remove maintop, see “Maintop” procedure.
3. Remove screws securing kick plate at each top
corner.
4. Remove screws securing regulator and gas train
brackets in place.
5. Disconnect gas line from regulator.
6. Disconnect gas line at top of unit going to manifold.
7. Remove gas train from unit.
8. Reverse procedure to reassemble.
Door Latch
1. Disconnect power supply to unit.
2. Remove screws securing latch cover.
3. Remove screws on far sides of latch plate.
4. Slide latch assembly out of unit chassis
5. Disconnect and label wire terminals on latch
assembly.
6. Reverse procedure to reassemble.
Control Box
1. Disconnect power supply to unit.
2. Remove screws securing kick plate at each top
corner.
3. Remove screws securing control box to unit chassis.
4. Carefully slide control box out, to gain access to
relays.
NOTE:
On replacement of any components in the
control box, verify proper wire location.
5. Reverse procedure to reassemble.
High Temperature Cutout
NOTE:
High Temperature Cutout is located in the center
of the unit, underside of the oven cavity.
1. Reset the switch when needed by pressing in button
on bottom of switch.
2. Switch can be replaced, by removing screws,
detaching wires, and replacing.