WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
©2004 Maytag Services
16022880 Rev. 0
17
Terminal Block
1. Disconnect power supply to unit.
2. Remove control panel, see “Control Panel” procedure.
3. Remove screws securing static handle located under
the static handle and above the lower heat shield.
4. Remove screws securing lower heat shield on the top
side of the heat shield.
5. Remove screws securing terminal block to chassis.
6. Mount new block and transfer wires from old block to
new block.
NOTE:
Make sure wires are transferred to correct
location on terminal block to ensure proper
operation.
7. For upper terminal block replacement, maintop needs
to be removed, see “Maintop” procedure.
8. Reverse procedure to reassemble.
Spark Module
1. Disconnect power supply to unit.
2. Remove control panel, see “Control Panel” procedure.
3. Locate spark module behind the manifold assembly.
4. Only remove the quick disconnect plug located on
spark model at this time.
5. Remove screws securing spark module to the front
baffle.
6. Carefully rotate module around the top of the manifold.
NOTE:
For easier removal of spark module. Landing
ledge may be removed for easier access by
removing the screws located on each end.
7. Once spark module is removed, transfer high voltage
wires onto the new spark module, ensuring proper wire
placement.
NOTE:
Failure to transfer high voltage wires correctly will
result in improper spark operation.
8. Reverse procedure to reassemble.
Single Feed Burner Gas Valve
1. Disconnect power and shut off gas supply to unit.
2. Remove control panel, see “Control Panel” procedure.
3. Remove screws securing landing ledge located on
each end.
4. Remove burner switches, by removing C-clip and
sliding switch off of valve shaft.
5. Remove compression nut on backside of valve.
NOTE:
Take care not to bend or damage tubing.
6. Remove valve clamp.
NOTE:
Check for leaks before installing control panel.
7. Reverse procedure to reassemble.
NOTE:
When reinstalling, ensure valve and gasket is
seated on manifold and tighten down valve clamp
evenly.
Dual Feed Gas Valve
1. Disconnect power and shut off gas supply to unit.
2. Remove control panel, see “Control Panel” procedure.
3. Remove screws securing landing ledge located on
each end.
4. Remove any necessary components to gain access to
the valve being replace (transformer, terminal block,
etc.).
5. Disconnect and label wire terminals from the burner
switch.
6. Remove simmer gas line and the main gas line.
NOTE:
Take care not to bend or damage tubing.
7. Remove valve clamp.
NOTE:
Check for leaks before installing control panel.
8. Reverse procedure to reassemble.
NOTE:
When reinstalling, ensure valve and gasket is
seated on manifold and tighten down valve clamp
evenly.
