Jenn-Air JXT5830ADB, Сервисная инструкция, Страница: 15 / 34

©2004 Maytag Services 16023510 15
WARNING
!
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
Disassembly Procedures
Transformer Removal
1. Disconnect power to vent hood.
2. Remove grease filters by using handles and pulling
filter toward the rear of the vent hood.
3. Pivot front of filter upward, then pull the filter
downwards and toward the rear to remove.
4. Remove light panel, see "Light Panel Removal"
procedure.
5. Discharge capacitor by connecting a one end of a
jumper wire to the capacitor terminal with the diode
connection and the other end to a well insulated
screwdriver. Touch the screwdriver to a chassis
ground. Remove jumper wire.
6. Remove screws securing transformer.
7. Label and disconnect transformer electrical
connections.
8. Remove transformer.
9. Reverse procedure to reinstall transformer.
Blower Motor Removal
1. Disconnect power to vent hood.
2. Remove grease filters and covers, see "Grease Filter/
Grease Filter Cover Removal" procedure.
3. Remove screws securing blower motor covers.
4. Remove blower wheel hub assembly.
5. Loosen set screws and remove blower motor wheel.
6. Remove screws securing blower motor to vent hood.
7. Label and disconnect blower motor electrical
connections.
8. Rotate blower motor counterclockwise to remove.
9. Reverse procedure to reinstall blower motor.
NOTE: When reinstalling motor, ensure washers
removed in Step 6 are installed over edge of
blower motor housing.
NOTE: When reinstalling motor, ensure blower motor
shaft is flush with blower motor bushing.
Filter Spring Clip Removal
1. Disconnect power to vent hood.
2. Remove grease filters and covers, see "Grease Filter/
Grease Filter Cover Removal" procedure.
3. Locate and remove clip assemblies installed in vent
housing by gently pulling clip toward the front and up.
4. Reverse procedure to reinstall the filter spring clip.