27
Filter
The filter is a permanent type and should be cleaned when soiled.
Cleaning Method:
■
Turn off the downdraft ventilation system before removing the
filter.
■
Remove vent grate then lift the filter out of the vent chamber.
■
Clean the filter in the sink with warm water and detergent or in
the dishwasher.
■
Replace the filter.
The filter should always be placed at an angle. As you face
the front of the range, the top of the filter should rest against
the left side of the vent opening. The bottom of the filter
should rest against the right side of the vent chamber at the
bottom.
If the filter is flat against the fan wall, ventilation effectiveness
will be reduced.
Ventilation Chamber
The ventilation chamber, which houses the filter, should be
cleaned in the event of spills or when it becomes coated with a
film of grease.
Cleaning Method:
■
Mild household detergent or cleanser and paper towel, damp
cloth or sponge:
Apply detergent or cleanser to paper towel, damp cloth or
sponge, not directly to the ventilation chamber.
Oven Lights
The oven uses a 120-volt, 20-watt maximum halogen bulb. See
the “Assistance or Service” section to order. Ask for Part Number
74004458.
To Replace Oven Light:
Before replacing, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Use fingertips to grasp edge of bulb cover. Pull out and
remove.
3. Remove bulb from socket by pulling straight out of the
ceramic base.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage or decreasing the life of the new bulb,
do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into place.
6. Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door to the first stop position (opened about
4" [10.0 cm]).
2. Grasp door at each side. Do not use the door handle to lift
door.
3. Lift up evenly until door clears hinge arms.
To Replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.