NOTE
It is normal for the skewer to flex when larger cuts
of meat are being cooked.
If the meat scrapes on the cooking grids during any
part of the rotation, the cooking grids must be
removed.
Adjust the counter balance weight to balance the
heavier side of the meat and avoid lopsided rotation
of the rotisserie motor.
CAUTION
When using the rotisserie burner, remove the
warming rack. High heat from the burner may cause
the warming rack to bend.
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning on the
gas. If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use.
WARNING
Do not use the grill if the odor of gas is present.
Contact customer service at 1-800-554-5799.
Screw the regulator (type QCC1) onto the tank, and
leak check the hose and regulator connections
before operating the grill (See the “Leak Testing”
instructions on page 9).
Only the pressure regulator and hose assembly
supplied with the unit should be used. Never
substitute regulators. If a replacement is necessary,
contact customer service for proper replacement.
TO LIGHT THE GRILL BURNER
1. Make sure all the knobs are in the “OFF”
position, and then turn on the gas supply from
the LP tank.
2. The igniter is built into the valve. To ignite each
burner, simply press and turn the control knobs
to the “HI” setting. The valve will click as it
sends a spark to the pilot flame.
3. If the burner does not light, turn off the gas
supply, wait 5 minutes for any excess gas to
dissipate and then try again.
LIGHTING INSTRUCTIONS
Burner flames should be blue and stable with no
yellow tips, excessive noise or lifting.
Yellow flames indicate insufficient air. Noisy flames
or flames that lift away from the burner indicate too
much air (See the “GAS FLOW CHECK” section on
page 9).
MATCH LIGHTING
If the burner does light after several attempts, it can
be lit with a match.
1. Wait 5 minutes for any accumulated gas to
dissipate.
2. Insert a lit extended match or lighter through the
cooking grids to the burner.
3. Press and turn the control knob left to the “HI”
setting. Continue pressing the knob until the
burner ignites.
4. If the burner does not light within 4 seconds,
turn the knob off. Wait 5 minutes and try again.
TO LIGHT THE ROTISSERIE BURNER:
1. Open the lid, and press the knob for about 5
seconds without turning it. This will allow time
for gas to flow into the rear burner.
2. Turn the knob to the “HI” setting. While turning
the knob, press the igniter button to light the
rotisserie burner.
3. If the burner does not light, turn the control
knob to the “OFF” position.
4. If the igniter does not function, follow the
instructions above for match lighting.
Keep a spray bottle of soapy water near the
gas supply valve and check the connections
before each use.
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Each burner is adjusted prior to shipment.
However, variations in the local gas supply
may make minor adjustments necessary.
12
Содержание 720-0061-LP
Страница 20: ...EXPLODED VIEW 18...
