TOOLS REQUIRED TO REPLACE WHEELS:
10mm wrench and a 5mm Allen hex key. When the wheels are worn, simply remove
the old wheel and install the new wheel using the tools noted above. When tightening the nut and bolt, tighten just enough to where
the wheel is snug.
REPLACEMENT WHEELS:
W98RM = medium speed - W98RS = slow speed - W98RF = fast speed
TRACKING:
When the skis are assembled at Jenex the wheels are placed in an accurate
jig, so they are perfectly aligned with the shaft. However, just 0.25 mm misalignment in the
binding mounting screws can cause the ski to pull to the right or left. Many skiers are not
anatomically balanced and even if the bindings are mounted properly the skis can still pull to
one side. The front wheel fork has a very tight round hole on the left side of the fork and an
oval shaped hole on the right side. The rear fork is exactly opposite. The rectangular
aluminum alignment plate and the small round stainless-steel washer also have holes just
slightly larger than the bolt. If the ski pulls to the right or to the left, take a pencil and draw a
mark on both vertical sides of the alignment plate. (See photo) Loosen the front wheel nut
slightly. If the ski tracks to the right push the bolt in the right side oval shaped hole slightly
forward. If the ski tracks to the left push the wheel bolt backward and retighten the wheel
bolt. The pencil marks can be used to fine-tune the tracking. If the bolt in the front wheel has
been pushed to the end of the oval hole and the ski still does not track properly make
additional adjustments on the rear wheel.
WARRANTY:
Jenex Inc. warrants to the original purchaser, that Jenex will repair free of charge any item that under
normal service proves defective in material or workmanship, as determined by Jenex inspection, for a period of 24
months from the date of purchase. Warranty applies only if the skier’s weight is less than 195 pounds (88kg.)
Warranty does not include wear items like speed reducers, wheels or brake pads. The shafts and fork assembly are
not warrantied if the shafts and forks have abnormal scrape and gouge marks.
V2 Jenex, Inc. 172 South Street Milford, NH 03055
PH: 603-672-2600
Fax : 603-672-5751 [email protected] www.jenex.com