Pro & Quicksilver Operator Instructions
5
Recharging the Powerpette
®
Pro / Powerpette
®
Quicksilver
Before starting to operate, carefully check mains voltage and recharge batteries.
To charge the Powerpette
®
Pro / Powerpette
®
Quicksilver
1 Recharging tempe10°C to +35°C.
2 Plug the charger jack (6) into the base of the Powerpette
®
.
3 Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
4 Place Powerpette
®
onto bench stand.
5 Allow unit to charge for 14 hours from empty to fully charged.
6 Once the Powerpette
®
is fully charged, the charger automatically switches to a trickle charge opera-
tion and the red indicator will turn off. If the charge to the Powerpette
®
is interrupted and then re-
started, the charger starts its full 14 hour charging cycle again.
This will not damage the battery.
Only use the charger indoors and protect against moisture.
Fitting the Powerpette
®
Pro / Powerpette
®
Quicksilver wall bracket
The Powerpette
®
Pro bench stand is supplied ready to use as a wall bracket. When used as a bench
stand it is recommended that the wall fitting is
removed.
Bench stand
Wall bracket
