3
INITIAL INSPECTION
Carefully unpack the unit and accessories. Inspect for damages
made in shipment. If any damage is found, notify your
Jenco
representative immediately. All packing materials should be saved
until satisfactory operation is confirmed.
POWER INPUT
The model 6177M/6177EU can be powered by an UL/CE approved
100 to 240 VAC adaptor as well as 6 “AAA” alkaline batteries.
Check the label on the AC adaptor supplied with the instrument to
make sure that the AC line voltage is correct. If the wrong AC
adaptor is supplied, notify your
Jenco
representative immediately.
INSTALLING THE BATTERIES
To insert the batteries into the meter, follow the procedure outlined
below.
1.
Use a Philip screw driver and unlock the battery cover by
turning the screw driver in the counter clockwise direction.
After unlocking the screw, take off the battery cover (Fig.1)
2.
Replace the old batteries with new ones and install them in the
correct polarity position.
3.
Put the battery cover back on the instrument. Use a Philip
screw driver and turn the screw in the clockwise direction to
lock the battery cover.
Figure 1: Battery compartment
