2.1.2 Skills Needed for the Installation
A combination of basic mechanical skills (drilling and filing) and electronic skills (soldering
and de soldering) are required. If you do not possess these skills then I strongly recommend
-
finding someone who does. Otherwise you may end up damaging your synth.
2.1.3 Preparing The Workplace
□
Unplug the synth from the electrical socket. Do not just turn the socket off – you need to
actually unplug the cable from the power socket.
□
Place the synth on a dry, soft surface, for example a table covered in a large towel.
2.2 Step by Step Installation
- -
Once you are all set up and ready to go, proceed with the following steps. Throughout these
instructions it is assumed that the synth is arranged with the keyboard at the front, as shown
in the picture below.
2.2.1 Opening The Jen SX1000
□
Carefully turn the synth over and rest it on a cloth or pillow.
□
Remove the two keyboard screws near the front of the synth and them and keep them safe.
□
Turn the synth so it is facing up.
□
Remove the six fixing screws that hold the main panel to the wooden base. There are three
on each side, with one on the front and two on the rear. Keep them safe in a tin or bag.
-
6
-
