Jema Autolifte JA4000F, Руководство по эксплуатации и обслуживанию

Страница: 8 / 41

8
2.3 Optional parts
1. Jacking beam light
3. Installation instructions
3.1 Preparations before installation
3.1.1 Tools and equipments needed

Appropriate lifting equipment

Anti-abrasion hydraulic oil.
 Rotary Hammer Drill with 3/4’’ drill bit.

Chalk and tape measure, magnetic plump, 8 meters ø15 level pipe.

Sockets and open wrenches, a set of inside hex wrenches, cross and straight screw drivers.

Hammer, 4pounds, sharp nose pliers, ø17,ø19,ø22 socket spanners
。
3.1.2 List for parts checking ---Annex 1
（
Packing list
）
Unfold the package and check if any parts missed as per Annex 1. Do not hesitate to contact us in case any parts missed, but if
you do not contact us and insist installing upon the lack of some parts, Jema Autolifte A/S as well as our dealers will not bear any
responsibility for this and will charge for any parts subsequently demanded by the buyer.
3.1.3 Ground conditions
The lift should be fixed on a smooth and solid concrete ground with its strength more than 3000psi, tolerance of flatness less than
5mm and minimum thickness of 200mm. In addition, newly built concrete ground must undergo more than 28days
’ cure and
reinforcement.
3.2 Precautions for installation
3.2.1 Make sure the four posts stand paralleled and are vertical to the ground. No slanting.
3.2.2 Joints of oil hose and steel cable must be firmly connected in order to avoid the looseness of steel cable and leakage of oil
hose.
3.2.3 All bolts should be firmly screwed up.
3.2.4 Do not place any vehicle on the lift in the case of trial running.