JELLY BELLY SNO MOTION, Инструкция по эксплуатации

Страница: 4 / 20

4
U
SING
Y
OUR
E
LECTRIC
I
CE
S
HAVER
1. If using paper cone cups, push cup holder into opening on front of ice shaver
housing. If using regular cups, do not attach cup holder.
2. Slide the gear ring over the auger and snap in place. You will hear a click when
it is fully engaged.
3. Place the auger with gear ring inside the exterior bowl. Lock the auger in place
with the securing nut by turning nut clockwise.
4. Line up the two outside tabs of the exterior bowl assembly with the matching
grooves on the Ice Shaver Housing. Push gently in place to secure. CAUTION:
The exterior bowl contains a sharp shaving blade, handle with care.
5. Place paper cone cups in cup holder. If using regular cups, place cup under the
shaving blade on the drip tray.
6. Add ice cubes to auger.
7. Plug the Ice Shaver into a 120 volt, AC electric outlet only.
8. Place the lid on top of the exterior bowl, aligning the tabs. Turn the lid counter-
clockwise until the lid tab engages the interlock switch. The motor will start and
the ice will begin shaving.
9. To stop shaving ice, turn the lid clockwise to disengage the motor switch.
10. Unplug from power supply immediately after use. Note: There will always be a
small amount of ice remaining in the auger after shaving. Discard the remaining ice.
CAUTION: Do not run ice shaver continuously for longer than 5 minutes as
overheating may occur. Allow motor to cool down before repeat usage.
•
A small amount of smoke and/or odor may occur upon use due to the
release of manufacturing oils – this is normal.
•
Some minor expansion/contraction sounds may occur during use – this is
normal.
C
LEANING
Y
OUR
E
LECTRIC
I
CE
S
HAVER
1. Always unplug appliance before cleaning.
2. Hand wash parts in warm, soapy water. Rinse and dry thoroughly. CAUTION:
Be extremely careful of shaving blade in exterior bowl as blade is very sharp.
Note: Do not wash parts in a dishwasher.
3. Clean exterior of the appliance with a damp, soft cloth and wipe dry. Note: Do
not immerse motor housing in water or other liquid.
NEVER ATTEMPT TO SHARPEN SHAVING BLADE AS INJURY MAY OCCUR.
This appliance has no user serviceable parts.
H
ELPFUL
H
INTS
•
Be sure you have an adequate supply of ice cubes.
• If your motor is laboring or if you get poor shaving results, soften your ice cubes.
This can be done by letting your ice sit at room temperature for a few minutes,
or running briefly under cool tap water.
•
DO NOT overfill the auger; the cover should sit flush without forcing.
•
Cube shaped ice performs better than the half-moon shaped ice from ice
makers or round cubes from store-bought bagged ice.