JEI SteelBeast BM-12, Инструкции по безопасности и руководство оператора

Страница: 11 / 16

BM-12 Bevelling Machine
- 10 -
HOW TO USE THE TOOL

Effective control of the powerful tool requires two-handed operation at all
times for maximum control and safety.

Do not use this tool continuously for over 30 minutes.
 After using the machine for 30 minutes, have a break away from it for at
least 20 to 25 minutes.
 Protect your eyes from injury with safety glasses or goggles and dress
accordingly (refer to Personal Safety Section on page 2 of manual)
OPERATION
The machine must reach full speed before bevelling/deburring begins.
 Hold the machine keeping the support deck flat and securely to the work
piece. From the operator’s perspective, the spindle is spinning clockwise, so
always operate in the direction from left to right (up mill) following the
arrow.
 When performing inside bevels, work in a clockwise direction only. Follow
the arrow.
 Do not bevel more than about 2mm per pass. If more depth is needed,
make multiple passes until the desired bevel height is reached. This will
allow maximum tool life of the carbide inserts.
MAINTENANCE
1. Keep Tool Clean
Periodically blow out all air passages with dry compressed air. All plastic parts
should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic
parts. They could possibly dissolve or damage the material. (wear safety goggles
while using compressed air)
2. Lubrication
Every 100 hours of operation, have the gearbox grease replaced by a qualified
service technician.
3. Replace the impeller when worn
When the impeller becomes worn the workpiece surfaces will be machined
unevenly. Replace when worn as follows:

Using the supplied hook spanner wrench, engage one of the holes in the
tool holder to immobilize it.

Using an appropriate sized wrench loosen the nut securing the impeller
and remove.

Replacement is the opposite of removal.