JEI SOLUTIONS LTD
MAGBEAST HM40
5.2 (20130122)
Operators manual for Drilling Machine Magbeast HM40
- 11 -
4.3 Before you cut
Before positioning the machine on the work piece always make sure that:
-
work piece is made of steel;
-
thickness of work piece is at least 3/8” (10 mm)
-
surface of steel under the magnet is flat
-
wipe, brush or sand down clean surface where you intended to place the
drilling machine, so that you remove rust, paint, dirt etc which would reduce adhesive
power of the electromagnetic base.
Install drill bit, milling cutter or other tooling such as tap or reamer in the machine
before plugging it into mains. Then plug it in and position where you wish to use it.
Place the machine so that the tool is over the centre of the hole you intend to make
and turn the magnetic base ON.
Prior to use always make sure that the machine is secured from falling
down with original
chain (as described in paragraph 4 “Important rules of safe
use of drilling machine
”).
4.4 Cutting
- Cutting lubricant is highly recommended when cutting with twist drill and
annular cutters.
It’s allowed to use of emulsions formed from a mixture of water and drilling oil.
Do not use clean water for cooling and cutting lubricant.
The cooling system is an integral part of the machine and should always be used.
(see point 4.9)
Warning: The cooling system can only be used when drilling machine is
in vertical position. In other positions additional external source of cooling
should be used, for example: a coolant bottle with a long nozzle or JEI Turbo
End spray/paste
-
Check working condition
of cooling system. Open coolant reservoir’s tap and
apply pressure on the pilot by turning spokes counter clockwise. As the pilot starts to
sink into the cutter, the cutting lubricant should start to run down cutters inner wall. If
there is no liquid flowing down check if the tap is fully opened. It may take a few
seconds for cooling liquid to fill the whole system.
-
Turn the motor on.
