WWW.JEIUK.COM
PRO 132T
This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
12
3.3. Installing and removing the annular cutter
Install the arbor as described before. Use gloves to put the correct pilot pin into the
annular cutter (
1
). Use a dry cloth to clean the cutter. Put the cutter into the arbor (
2
)
to align the flat surfaces (
3
) with the screws (
4
). Use the 5 mm hex wrench to tighten
the screws.
To remove the cutter, loosen the screws (
4
) with the 5 mm hex wrench.
1
2
4
3
