IMPORTANT SAFETY INSTRUCTIONS
15. USE EYE PROTECTION. Use a full-face mask if the work you're doing produces metal filings, dust or wood chips.
Goggles are acceptable in other situations. Wear a clean dust mask if the work involves creating a lot of fine or coarse
dust.
16. SECURE WORK. Use clamps or a vise to hold the work. It's safer than using your hands and it frees both hands to
operate the tool.
17. DON'T OVERREACH. Keep proper footing and balance at all times. Do not reach over or across machines that are
running.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer performance. Follow instructions
for lubricating and safe performance. Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS OR WRENCHES before turning the
tool on. Left attached, these parts can fly off a rotating part and result in personal injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have your tool repaired before using it.
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY ADJUSTMENTS. Changing attachments or
accessories can be dangerous if the tool could accidentally start.
23. STAY ALERT. Watch what you are doing & use common sense. Don't operate any tool when you are tired.
24. CHECK FOR DAMAGED PARTS. Before using this tool, any pad that is damaged should be carefully checked to
determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mountings, and other conditions that may affect its operation. Inspect screws and
tighten any ones that are loose. Any part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual. Have defective switches replaced by an
authorized service center. Don't use the tool if switch does not tum it on and off properly.
25. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
26. SERVICE AND REPAIRS should be made by qualified repair technicians at an authorized repair center. Improperly
repaired tools could cause serious shock or injury.
SAFETY PRECAUTIONS FOR CUT-OFF SAW
1. Make sure the cut-off wheel is securely mounted as described in the assembly instructions before connecting the tool
to a power supply. Do not tighten wheel excessively, since this can cause cracks.
2. Check wheel for fissures and cracks, and test for normal operation prior to use.
3. Use only cut-off wheels rated for 4400 rpm or greater and manufactured in compliance with ANSI B7.1. Always store
the wheels in a dry place with little temperature variation.
4. Always ease the abrasive wheel against the work piece when starting to cut. A harsh impact can break the wheel.
5. Always press the trigger switch and allow the cut-off wheel to reach full speed before cutting.
SPECIFICATIONS
14" (355 mm) Metal Cut-Off Saw
120v. 60Hz 15 amp motor
2800 rpm no-load speed
Cuts material up to 4.25
” diameter
With correct blade, can be used to cut conduit, ABS, copper pipe, even concrete
Vise assembly with quick release adjusts 0-45° for angle cutting
Max cutting depth: 110 mm @ 90° & 115 mm @ 45°
Includes
14" dia. x 1/8" thick x 1" arbor metal-cutting wheel
Vise assembly with quick release
1-800-345-4545 jegs.com
