USER MANUAL
JEFVACWD035-230
35L
WET & DRY VACUUM CLEANER
•
1400W
•
230V
~
50Hz
USER MANUAL
JEFVACWD035-230
35L
WET & DRY VACUUM CLEANER
•
1400W
•
230V
~
50Hz
www.jeffersontools.com
www.jeffersontools.com
4
5
Read and ensure that you understand all of the operating instructions, safety precautions and warnings in this Instruction
Manual before operating or maintaining this equipment. Most accidents that occur in the working environment are caused
by the failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing a potentially
hazardous situation before it occurs, and by observing appropriate safety procedures. Never use this equipment or modify
it in any way that has not been specifically recommended by the manufacturer
.
Contact a qualified electrician for advice on
any issues relating to electrical safety in your working environment.
ELECTRICAL SAFETY
Ensure that you check the equipment thoroughly to ensure it is safe and fit for purpose before each
use. It is important that you inspect all plugs, sockets, power cables and electrical fittings for wear
and damage and repair or replace any defective components. The risk of electric shock can be
minimised by the correct use of the appropriate electrical safety devices.
•
We recommend that you fit a
Residual Current Circuit Breaker (RCCB)
in the main distribution board and that
a
Residual Current Device (RCD)
is used when operating this equipment.
•
The
Electricity at Work Act 1989
includes legislation that places legal implications on employers to ensure
the safety of electrical devices in the workplace. The regulations dictate that all portable equipment must be
inspected regularly and tested to ensure that it is safe for use. 'Portable equipment' means any electrical item
that can be moved and this is often referred to as
Portable Appliance Testing (PAT)
. PAT testing should be
carried out regularly on this equipment by trained, authorised personnel, as required by the legislation.
•
The
Health and Safety at Work Act 1974
states that it is the responsibility of the owner of electrical appliances
to ensure that both the equipment and working environments are maintained to ensure safe operation at all
times.
•
Check that all equipment cables are secure, correctly insulated, free from damage, and protected against short
circuit and overload before connecting to the power supply. Do not use worn or damaged cables, plugs, sockets
or other fittings.
•
Ensure that the power supply matches voltage requirements specified on the equipment and that the plug is
wired correctly and fitted with the correct fuse.
•
If the electrical fuse blows, ensure it is replaced by an identical type of fuse with the same rating.
•
Never pull or manoeuvre this equipment into position using the power cable (move using the handle).
•
Ensure the power cable is kept away from heat, oil and sharp edges.
•
We recommend that the equipment is connected directly to the power supply without the use of extension leads
as the resulting voltage drop can reduce motor and pump performance.
•
Always disconnect the equipment from the power source before servicing, inspecting, maintaining, cleaning,
replacing or checking any parts.
SAFETY GUIDELINES
EQUIPMENT SAFETY
•
Never clean with solvents - the equipment has not been designed for use with solvents or detergents.
•
Ensure that equipment is used by responsible operators. Keep away from children and animals.
•
Never leave equipment unattended, especially when connected to the power supply.
•
Never use this equipment to vacuum any of the following materials:
- Burning matches
- Glowing ashes
- Lit cigarette ends
- Inflammable materials
- Corrosive materials
- Explosive substances, vapours or liquids
•
This equipment is not suitable for vacuuming dust or debris which is toxic or damaging to health.
•
Store the equipment in a dry and secure location when not in use.
•
Contact your nearest Jefferson Dealer for any additional advice required on the safe use or maintenance or repair
of this equipment.
•
Only use the attachments and spare parts supplied by Jefferson Tools.
