Jefferson JEFPDB0350, Руководство пользователя

Страница: 6 / 20

www.jeffersontools.com
User Manual
v.1.1
JEFPDB0350
2. MAINTENANCE
2.1 Read this manual carefully.Learn the machine applications and limitations,as well as the specific potential hazards peculiar to it.
2. 2 ALWAYS keep guards in place and in working order. A guard or other part that is damaged should be properly repaired or replaced by an
authorized serv ice centre, unless otherwise indicated in this instruction manual.
2. 3 Remove any adjusting keys or wrenches before starting. Form the habit of checking to ensure that keys, wrenches and tools
are removed from the machine.
2.4 Don’t force the machine and use the correct tool. It will do the job better and safer, at the rate for which it was intended.
2.5 ALWAYS disconnect the machine from the power supply before carrying out any servicing or changing of accessories.
2.6 Before further use of the tool, it should be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting or other condition that may affect its operation.
2.7 Have defective switches repaired by an authorized service centre. Do not use a tool if the switch does not turn it on and off.
2.8 ALWAYS check for any damage or any condition that could affect the operation of the machine. Damaged parts should be properly repaired.
2.9 NEVER remove the cover panel unless the machine is disconnected from the power supply, and never use the machine
with cover panels removed.
2.10 Have your tool repaired by a qualified person. This tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
2.11 NEVER use this product for any other purpose than that described in this booklet.
2.12 NEVER abuse the power cable by yanking the cable to disconnect it from the socket. Keep the cable away from heat, oil or sharp edges.
2.13 Guard against electric shock. Avoid body contact with earthed or grounded surfaces.
2.14 If the tool should be used outdoors, use only extension cables intended for outdoor use and marked accordingly.
2.15 Avoid accidental starting by making sure the power switch is off before plugging in the power cable.
MONTHLY MAINTENANCE (IF IN REGULAR USE)
2.16 Check tightness of mounting bolts, and head and column securing set screws.
2.17 Check the drive belt for wear, and replace if frayed or damaged.
2.18 Blow out with compressed air, or vacuum clean out, any dust that may have accumulated in the motor fan vents.
2.19 Apply a thin coat of wax paste or light oil to the table and column, for lubrication, and to help prevent corrosion.
2.20 If the mains lead is damaged in any way, it should be replaced immediately.
LUBRICATION
All bearings are packed with grease at the factory and require no further lubrication.
Occasionally, lubricate the quill shaft assembly and rack with light oil if required.
Fig.44 Fig.45
AFTER USE
Remove all swarf from the machine and thoroughly clean all surfaces. Components should be kept dry, with machined surfaces lightly oiled.
Always remove drill bits, and store in a safe place.