Jefferson JEFHOSRLH15-1/2, Руководство пользователя

Страница: 7 / 16

7
USER MANUAL
15M - 1/2" Industrial Auto Retracting Air Hose Reel
JEFHOSRLH15-1/2
•
Check reel for correct operation by slowly pulling out the hose. A “clicking” nose will be heard every half revolu-
tion of the drum
•
To latch the reel, pull out the hose and allow it to retract after hearing the first second or third “click”
•
To unlatch, slowly pull out the hose until the “clicking” noise stops, and then let the hose retract until the hose
stop rests against the hose guide
•
Periodically check the hose condition for wear or damage, and check the swivel fitting for leakage. Replace any
worn, damaged, or leading parts
Adjusting the Spring Tension
•
Pull out approximately 6ft or 2m of hose and allow the drum to latch
•
Remove hose stopper from hose, and feed hose back through guide
•
Wrap the pulled hose one time around the drum to increase tension or unwrap hose one time from drum to de-
crease intension
•
Re-insert hose through guide, and install stopper onto hose end
•
Unlatch the drum and check tension. Pull hose from reel, and adjust stopper position if necessary
Replacement of the Swivel Seals
Note: There are two types of swivel arrangements
•
Turn off and disconnect the air supply line from the swivel inlet
•
Remove the swivel assembly from the reel axle
•
Hold the fitting body in a vice. Remove the brass tube from the body, and remove the swivel nut from the tube
•
Replace the seals and reassemble swivel. Apply pipe sealant to brass tube threads, thread into fitting body and
tighten
•
Re-connect the swivel to the reel axle and tighten
•
Re-connect the air inlet supply line
Replacing the Hose
•
Turn off the air supply to the hose reel
•
Pull out all of the old the hose and lock the reel in this position.
Caution:
Make sure reel drum is securely locked and can’t rotate back
•
Carefully disconnect the hose from the male fitting in the centre of the axle and remove the old hose
•
Feed the new hose through the guide and the opening in the drum, and connect to male fitting.
•
Install stopper on other end of hose in the same position as before
•
Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Note:
The final spring adjustment is accomplished by adding or removing wraps of hose around the drum.
4. Operation
5. Maintenance
Warning:
If the rewind spring fails for any reason contact your nearest Jefferson Dealer to organise
replacement / repair of the spring canister.