3
USER MANUAL
HVLP Gravity Spray Gun
JEFA048
•
1.4mm nozzle
•
0.6 Litre plastic cup with integrated drip-catching device
•
Variable round/flat spray control
•
Air micrometer
•
Universal wrench
•
Hollow key
2. Box Contents
Caution:
When using solvents and cleaning agents based on halogenated hydrocarbons e.g. 1.1.1-trichlorethylene and
methylene chloride, chemical reactions can occur on the aluminium cup, gun and on galvanized components (for example: small
quantities of water added to 1.1.1-trichlorethyelen produce gydrochloric acid). This can cause oxidation of the components: in
extreme cases, the reaction can be explosive. Therefore only use solvents and cleaning agents for your paint gun which do not
contain the substances named above. Never use acid for cleaning purposes.
Warning:
Never point paint guns at yourself, at other persons or animals. Solvents and diluting agents can cause burns. Before
any repair work may be carried out, the unit must be disconnected from the compressed air network and pressure must be
released. Before starting to use the paint gun, Particularly after repairs, ensure that screws and nuts are correctly tightened,
and check that gun and hoses do not leak. Defect components must be replaced or repaired, use original spare parts only. No
sources of ignition (e.g. open flames, burning cigarettes, lamps without ex-protection etc.) may be present during painting, as
easily flammable mixtures are generated during the painting process. Occupational safety regulations must be applied when
painting (respirator protection etc.). Appropriate ear protection muffs are required, as a sound level of 90dB(A) can be
exceeded when painting under higher pressure levels.
4.1 Safety Checks Before Use
1.
Before using the gun check that all nuts and bolts and detachable parts are securely tightened.
2.
Always disconnect the unit from the air supply before removing any parts or carrying out any adjustments.
3.
Mount the nozzle set tightly. Align the air nozzle so that the number stamped into it can be read from the front
the right way round.
4.
Blow out the air hose to remove any dust and debris before attaching it to the air connection.
5.
Rinse/flush the spray gun thoroughly before use. This is important as the gun has been treated with an
anticorrosive agent before leaving the factory and must therefore be flushed out thoroughly with thinner
before use.
4. Operating Instructions
3. Specification
Air Pressure
43psi / 3bar
Air Inlet
¼"
Air Consumption
15cfm
Cup Capacity
600ml
Feed Type
Gravity
Fluid Nozzle
1.4mm
JEFA048
