Jefferson Professional Tools & Equipment 6.5HP, Руководство пользователя

Страница: 11 / 32

11
USER MANUAL
v2.1
JEFWASPGRO65HP
6.5HP Gearbox Petrol Washer
www.jeffersontools.com
Warning:
Do not run the pump without the water supply
connected and turned on.
Please Note:
Any damage resulting from failure to follow this
instruction will void the warranty on this equipment.
6.
Turn on the water, point the gun in a safe direction and squeeze the
trigger to purge the pump system of air and impurities (See
Fig 15
.).
7.
Attach the lance to the spray gun and tighten by hand until secure.
8.
Choose the nozzle you require for the job at hand, pull back the collar
on the quick fitting, insert the nozzle and release the collar to connect.
Tug on the nozzle to make sure it is securely connected.
9.
Turn the fuel shut off valve to the
"On"
position. (See
Fig 16
.)
10.
Move the throttle control lever to the
"High"
position (indicated by
the rabbit icon on the engine). (See
Fig 17
.)
11.
Move the choke lever to the
"Choke"
position (See
Fig 17
.)
Note:
For warm engines ensure that the choke is in the
"Run"
position.
Warning: Before starting the pressure washer be sure you are
wearing the appropriate Personal Protection Equipment (PPE) for the
job at hand. Safety goggles should always be worn when using this
pressure washer.
12. When starting the engine, position yourself as shown in Fig 18. Grip
the starter handle and pull slowly until you feel some resistance. Then
pull rapidly to start the engine.
13. Return the starter grip handle slowly. Do not allow the starter cord to
"snap back" against the starter.
14. When the engine starts, slowly move the choke lever to the "Run"
position as the engine warms up. If the engine falters during this step,
move it back to the
"Choke" position, then back to the "Run" position.
15. If the engine fails to start, point the spray gun in a safe direction and
squeeze the trigger to release any pressure.
16. If the engine fails to start after 6 attempts, move the choke lever to
the "Run" position and repeat steps 13-15 .
Important: Allow the engine to run at no load, low pressure for at least 5
minutes after each startup.
Warning: The spray gun retains high water pressure even when
the engine is stopped and disconnected. Aways discharge this by
squeezing the trigger on the spray gun, pointing in a safe direction.
15.
16.
17.
18.