INSTRUMENT CLUSTER
DESCRIPTIONS — PHEV ONLY
1.
Tachometer
○
Indicates the engine speed in revolutions per
minute (RPM x 1000).
CAUTION!
Do not operate the engine with the tachometer
pointer in the red area. Engine damage will occur.
2.
Engine Coolant Temperature
○
This gauge shows the engine coolant tempera-
ture. The gauge pointer will likely show higher
temperatures when driving in hot weather, up
mountain grades, or in heavy stop and go traf-
fic. If the red Warning Light turns on while driv-
ing, safely bring the vehicle to a stop, and turn
off the engine. DO NOT operate the vehicle until
the cause is corrected.
WARNING!
A hot engine cooling system is dangerous. You or oth-
ers could be badly burned by steam or boiling cool-
ant. It is recommended to call an authorized dealer
for service if your vehicle overheats.
CAUTION!
Driving with a hot engine cooling system could dam-
age your vehicle. If the temperature gauge reads “H”
pull over and stop the vehicle. Idle the vehicle with
the air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H”, turn the engine off immediately and call an
authorized dealer for service.
3.
Instrument Cluster Display
○
The instrument cluster display features a driver
interactive display. When the appropriate condi-
tions exist, this display shows messages
4.
Fuel Gauge
○
The pointer shows the level of fuel in the fuel tank
when the ignition is in the ON/RUN position.
○
The fuel pump symbol points to the
side of the vehicle where the fuel
door is located.
5.
Power/Charge Gauge
○
This gauge represents the source of the power
utilized to accelerate the vehicle. The green
outer ring represents the High Voltage (HV) bat-
tery output during acceleration, and input power
during regeneration. The yellow inner ring repre-
sents the engine output power.
GETTING TO KNOW YOUR INSTRUMENT PANEL
123
3
5538906_24_JL_OM_EN_USC_t_E1.pdf 123
5/22/2023 9:02:21 AM