Jeep WRANGLER 2023, Руководство пользователя

Страница: 51 / 92

STARTING AND OPERATING 49
AutoPark will engage when all of these conditions
are met:

Driver’s door is ajar or the driver’s door is
removed and the driver is not on the seat (seat
pad sensor detects driver missing)

Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver’s seat belt is unbuckled

Brake pedal is not pressed
The message “AutoPark Engaged Shift To P Then
Shift To Gear” will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster. In these cases,
the gear selector must be returned to “P” to select
desired gear.
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed is
1.2 mph (1.9 km/h) or less.
The message “Vehicle Speed Is Too High To Shift
To P” will be displayed in the instrument cluster if
vehicle speed is above 1.2 mph (1.9 km/h).
4WD LOW
AutoPark will be disabled when operating the
vehicle in 4WD LOW.
The message “AutoPark Disabled” will be
displayed in the instrument cluster.
Additional customer warnings will be given when
both of these conditions are met:

Vehicle is not in PARK

Driver’s door is ajar
The message “AutoPark Not Engaged” will be
displayed in the instrument cluster. A warning
chime will continue until you shift the vehicle into
PARK or the driver’s door is closed.
ALWAYS DO A VISUAL CHECK that your vehicle is in
PARK by looking for the “P” in the instrument
cluster display and on the gear selector. As an
added precaution, always apply the parking brake
when exiting the vehicle.
A
FTER
S
TARTING
To optimize energy efficiency, the vehicle will
automatically control engine operation.
T
O
T
URN
O
FF
T
HE
V
EHICLE
U
SING
ENGINE START/STOP B
UTTON
1. Place the gear selector in PARK, then push
and release the ENGINE START/STOP button.
2. The ignition button indicator will return to the
OFF position.
3. If the gear selector is not in PARK, with vehicle
speed less than 5 mph (8 km/h), when the
ENGINE START/STOP button is pushed, the
instrument cluster display will display a
“Vehicle Not In Park” message, and the vehicle
will remain running.
4. If the gear selector is not in PARK, with vehicle
speed greater than 5 mph (8 km/h), when the
ENGINE START/STOP button is pushed contin -
uously for at least two seconds (or three short
pushes in a row), the vehicle ignition will exit
the Ready mode and enter Accessory mode.
Never leave a vehicle out of the PARK position,
or it could roll.
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h), the
transmission will default to NEUTRAL until the
vehicle speed drops below 1.2 mph (1.9 km/h).
A vehicle left in the NEUTRAL position can roll. As
an added precaution, always apply the parking
brake when exiting the vehicle.
4
23_JL_H_SU_EN_USC_t.book Page 49