Jeep WG Grand Cherokee 2002, Руководство по обслуживанию

Страница: 22 / 74

TEST ACTION APPLICABILITY
4 Turn the ignition off.
Disconnect the Adjustable Pedals Motor/Sensor harness connector.
Operate the Adjustable Pedals Switch to the Fwd position.
On the APM side of the connector, using a 12-volt test light connected to ground,
check the Fwd circuit.
On the APM side of the connector, using a 12-volt test light connected to 12-volts,
check the Aft circuit.
Does the test light illuminate brightly at each pin? All
Yes
→
Repair any wiring concerns. If no concerns are found, replace the
Adjustable Pedals Motor/Sensor assembly.
Perform ADJUSTABLE PEDALS VERIFICATION TEST - VER
1.
No
→
Go To 5
5 Turn the ignition off.
Disconnect the Adjustable Pedals Module harness connector.
Disconnect the Adjustable Pedals Motor/Sensor connector.
Check the FWD and AFT circuits for short to battery, to ground, to each other and for
an open.
Is the FWD or AFT circuit shorted or open? All
Yes
→
Repair the Adjustable Pedals Motor FWD or AFT circuit short or
open as necessary.
Perform ADJUSTABLE PEDALS VERIFICATION TEST - VER
1.
No
→
Replace and program the Adjustable Pedals Module in accordance
with the Service Information.
Perform ADJUSTABLE PEDALS VERIFICATION TEST - VER
1.
6 Turn the ignition off.
Disconnect the Adjustable Pedals Module harness connector.
Disconnect the Adjustable Pedals switch connector.
Measure the resistance of the Battery Feed circuit.
Is the resistance above 5.0 ohms? All
Yes
→
Repair the Battery Feed circuit for an open.
Perform ADJUSTABLE PEDALS VERIFICATION TEST - VER
1.
No
→
Replace the Adjustable Pedals Switch.
Perform ADJUSTABLE PEDALS VERIFICATION TEST - VER
1.
20
ADJUSTABLE PEDALS
*CAN’T ADJUST PEDALS —
Continued
ProCarManuals.com