Jeep GRAND CHEROKEE L 2023, Руководство пользователя

Страница: 161 / 424

STARTING AND OPERATING 159

If the suspension alignment is not correct, if the
vehicle is modified (e.g. lifting or lowering the
suspension, installing different sized wheels or
tires) or if there has been damage due to road
hazards

Driving near highway toll booths
NOTE:
If damage to the windshield occurs, have the wind -
shield replaced by an authorized dealer as soon as
possible.
PARKSENSE FRONT/REAR PARK ASSIST
SYSTEM — IF EQUIPPED
The ParkSense Park Assist system provides visual
and audible indications of the distance between
the rear, and if equipped, the front fascia/bumper
and a detected obstacle when backing up or
moving forward (e.g. during a parking maneuver).
The vehicle brakes may be automatically applied
and released when performing a reverse parking
maneuver if the system detects a possible collision
with an obstacle.
NOTE:

The driver can disable the automatic braking
function by turning ParkSense off via the
ParkSense switch. The driver can also override
automatic braking by changing the gear or by
pressing the gas pedal over 90% of its capacity
during the braking event.

Automatic brakes are not available if the vehicle
is in 4WD Low.

Automatic brakes will not be available if there is
a faulted condition detected with the ParkSense
Park Assist system or the Braking System
Module.

The automatic braking function may only be
applied if the vehicle deceleration is not enough
to avoid colliding with a detected obstacle.

The automatic braking function may not be
applied fast enough for obstacles that move
toward the rear of the vehicle from the left and/
or right sides.

The automatic braking function can be
enabled/disabled from the Customer Program -
mable Features section of the Uconnect system.

ParkSense will retain its last known configura -
tion state for the automatic braking function
through ignition cycles.
The automatic braking function is intended to
assist the driver in avoiding possible collisions with
detected obstacles when backing up in REVERSE
gear.
NOTE:

The system is designed to assist the driver and
not to substitute the driver.

The driver must stay in full control of the
vehicle's acceleration and braking and is
responsible for the vehicle's movements.
4
23_WL_OM_EN_USC_t.book Page 159