Jeep GRAND CHEROKEE 4XE 2022, Руководство пользователя

Страница: 27 / 72

GETTING TO KNOW YOUR VEHICLE 25
Charge Settings — If Equipped
The fifth screen within the Hybrid Electric App is the
Charge Setting screen. From this screen, you can
select the rate at which your vehicle charges. Rate
selections 1 (low rate of charge) through 5 (high rate
of charge) are available. The lower the selected rate,
the longer amount of time it will take for your vehicle
to reach a full charge.
Charge Setting Screen
The Charge Setting can be adjusted by pressing
the “+” or “-” buttons, and the estimated time until
full charge will update on the right side of the
screen to reflect the selected Charge Setting.
NOTE:

The Charge Setting will be saved each time the
vehicle is turned off, then back on again.

For information on jump starting your vehicle,
refer to the “In Case Of Emergency” chapter in
the Owner’s Manual.
IGNITION SWITCH
This feature allows the driver to operate the
ignition switch with the push of a button as long as
the key fob is in the passenger compartment.
NOTE:
This vehicle is equipped with an automatic shutdown
feature. If the vehicle is left with the ignition in the
RUN position (engine not running) with gear selector in
PARK for 30 minutes, it will automatically turn off the
vehicle. If the driver door is opened, then closed while
propulsion is active and the vehicle is in PARK, the
vehicle will shut down. Notifications have been
designed into this feature to raise awareness of the
timed event. The instrument cluster display will show
the message “Ready to Drive” accompanied with three
audible chimes while exiting. The interior warnings will
occur regardless of whether the key fob remains in the
vehicle or is removed. The horn will sound three times,
and the turn signals will flash if the key fob is removed
from the vehicle and the ignition state is in READY
mode.
To restart the vehicle, follow the normal process for
starting your vehicle.
The START/STOP ignition button has several operating
modes that are labeled and will illuminate when in
position. These modes are OFF, ON/RUN, and START.
NOTE:

Pushing the START/STOP ignition button may only
activate the Electric Propulsion system and not start
the vehicle’s engine (if running the engine is not
currently required by the Hybrid system). READY will
show in the instrument cluster display whenever the
vehicle is operating in Electric mode and the vehicle
is stationary.

If the vehicle’s ignition is in the ON/RUN posi -
tion, the vehicle’s charge indicator may not
display a value greater than 99% state of charge
due to vehicle loads.
2
22_WL_H_SU_EN_USC_t.book Page 25