Jeep GLADIATOR 2023, Руководство пользователя

Страница: 35 / 420

GETTING TO KNOW YOUR VEHICLE 33
Use this QR code to access your digital
experience.
This vehicle may be equipped with
half-doors. To install the half-doors in
the vehicle, follow the instruction sheet
packaged in the box the doors were
received in. Replacement parts may be
purchased through Mopar® Service.
Half-Door Installation
To install the front or rear half-doors, proceed as follows:
1. Remove the full doors from the vehicle. For front
door removal, see
Ú
page 25. For rear door removal,
see
Ú
page 29.
2. Locate the upper and lower hinge pins on the lower
half-door, and lower them into the body hinges on
the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to assist
in guiding the door into place during installation.
Lower Half-Door Hinge Pins
3. Insert the upper and lower hinge pin screws into the
body hinges. Tighten the screws using a #T50 Torx
head driver to 3.8 ft· lb / 5.2 N·m.
4. Attach the cloth strap of the lower half-door to the
metal hook just inside the vehicle.
Cloth Strap Attachment
5. Connect the wiring harness on the lower half-door to
the connection just inside the vehicle.
NOTE:
For front doors, make sure the wiring harness is closed
completely.
Front Door Wiring Harness
6. Replace wiring access doors.
CAUTION!

Do not close the door before reattaching the door
check to the body. Damage may occur to the door
check.

Do not overtighten Torx fasteners, damage to the
vehicle’s parts will occur.

Hinge pins can break if overtightened during door
install (Max Torque: 6.0 ft· lb/8.1 N·m).
1 — Metal Hook
2 — Cloth Strap
1 — Open Wiring Harness
2 — Closed Wiring Harness
2
23_JT_OM_EN_USC_t.book Page 33