Jeep COMPASS 2018, Руководство пользователя

Страница: 41 / 712

Multifunction Lever
The multifunction lever controls the operation of
the turn signals, headlight beam selection and
passing lights. The multifunction lever is located
on the left side of the steering column.
High/Low Beam Switch
Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beams. Pulling the multifunction lever back to-
ward the steering wheel will return the lights to
low beams.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
clockwise to the last detent for automatic head-
light operation. When the system is on, the
headlight time delay feature is also on. This
means the headlights will stay on for up to
90 seconds after you place the ignition into the
OFF position. To turn the automatic system off,
move the headlight switch out of the AUTO
position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
Automatic High Beam Headlamp
Control — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror. This camera detects ve-
hicle specific light and automatically switches
from high beams to low beams until the ap-
proaching vehicle is out of view.
NOTE:
•
The Automatic High Beam Headlamp Control
can be turned on or off using the Uconnect
System. Refer to “Uconnect Settings” in “Mul-
timedia” for further information.
•
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function
improperly.
Headlight Time Delay
This feature provides the safety of headlight
illumination for up to 90 seconds (program-
mable) when leaving your vehicle in an unlit
area.
To activate the delay feature, place the ignition
in the OFF position while the headlights are still
on. Then, turn off the headlights within 45 sec-
onds. The delay interval begins when the head-
light switch is turned off.
If you turn the headlights or parking lights on, or
place the ignition in ACC or RUN, the system will
cancel the delay.
If you turn the headlights off before the ignition,
they will turn off in the normal manner.
NOTE:
•
The lights must be turned off within 45 sec-
onds of placing the ignition in the OFF posi-
tion to activate this feature. If the headlight
switch is in the AUTO position prior to turning
the ignition OFF, there is no need to turn the
headlight switch to off to activate Headlight
Delay.
•
The headlight delay time is programmable
using
the Uconnect System, refer to
“Uconnect Settings” in “Multimedia” for fur-
ther information.
Multifunction Lever
38