Jeep CHEROKEE 2017, Руководство пользователя

Страница: 25 / 86

Automatic Transmission
Start the engine with the transmission gear selector in the
PARK position. Apply the brake before shifting to any
driving range.
Extreme Cold Weather
The engine block heater is a resistance heater installed in
the water jacket of the engine. It requires a 110–115 Volt AC
electrical outlet with a grounded, three-wire extension
cord. Its use is recommended for environments that rou-
tinely fall below -10°F (-23°C). It should be used when the
vehicle has not been running overnight or longer periods
and should be plugged in two hours prior to start. Its use
is required for cold starts with temperatures under -20°F
(-28°C).
NOTE:
The engine block heater cord is a factory installed
option. If your vehicle is not equipped, heater cords are
available from your authorized Mopar dealer.
•
A 12 Volt heater built into the fuel filter housing aids in
preventing fuel gelling. It is controlled by a built-in
thermostat.
•
A Diesel Pre-Heat system both improves engine starting
and reduces the amount of white smoke generated by a
warming engine.
Normal Starting Procedure — Keyless Enter-N-Go
Observe the instrument panel cluster lights when starting
the engine.
NOTE:
Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal
1. Always apply the parking brake.
2. Press and hold the brake pedal while pushing the
ENGINE START/STOP button once.
NOTE: A delay of the start of up to five seconds is possible
under very cold conditions. The
⬙
Wait to Start
⬙
telltale will
be illuminated during the pre-heat process, When the
engine Wait To Start light goes off the engine will auto-
matically crank.
CAUTION!
If the “Water in Fuel Indicator Light” remains on, DO
NOT START the engine before you drain the water
from the fuel filters to avoid engine damage. Refer to
“Draining Fuel/Water Separator Filter” in “Servicing
And Maintenance” for further information.
4
STARTING AND OPERATING 23