Jeep 2018 WRANGLER, Краткое руководство пользователя

Страница: 12 / 24

2H/4H Auto To 4H Part Time Or 4H Part Time To
2H/4H Auto
Shifting between 2H/4H AUTO to 4H PART
TIME can be made with the vehicle stopped or
in motion. The preferred shifting speed would
be 0 to 45 mph (72 km/h). With the vehicle in
motion, the transfer case will engage/disengage
faster if you momentarily release the accelera-
tor pedal after completing the shift. Do not
accelerate while shifting the transfer case. Ap-
ply a constant force when shifting the transfer
case lever.
4H Part Time/4H Auto To 4L Or 4L To 4H Part
Time/4H Auto
With the vehicle rolling at 2 to 3 mph (3 to
5 km/h), shift an automatic transmission into
NEUTRAL (N), or press the clutch pedal on a
manual transmission. While the vehicle is coast-
ing at 2 to 3 mph (3 to 5 km/h), shift the transfer
case lever firmly to the desired position. Do not
pause with the transfer case in N (Neutral). Once
the shift is completed, place the automatic trans-
mission into DRIVE or release the clutch pedal on
a manual transmission.
NOTE:
• Shifting into or out of 4L is possible with the
vehicle completely stopped; however, diffi-
culty may occur due to the mating teeth not
being properly aligned. Several attempts
may be required for clutch teeth alignment
and shift completion to occur. The preferred
method is with the vehicle rolling at 2 to
3 mph (3 to 5 km/h). Avoid attempting to
engage or disengage 4L with the vehicle
moving faster than 2 to 3 mph (3 to 5 km/h).
• Do not attempt to make a shift while only the
front or rear wheels are spinning. The front
and rear driveshaft speeds must be equal for
the shift to take place. Shifting while only
the front or rear wheels are spinning can
cause damage to the transfer case.
• Delayed shifts out of four-wheel drive may be
experienced due to uneven tire wear, low or
uneven tire pressures, excessive vehicle
loading, or cold temperatures.
• Shifting effort will increase with speed, this
is normal.
During cold weather, you may experience in-
creased effort in shifting until the transfer case
fluid warms up. This is normal.