Jeanneau Merry Fisher 645, Руководство пользователя, Страница: 21 / 84

17/80
RECOMMENDATIONS FOR GAS
Type of cylinder: butane, service pressure 10 kg/cm
2
or according to current standards of
your country).
Close the valves on the system and on the cylinder when the appliances are not used.
Close the valves before you change cylinders and immediately in case of emergency.
Never leave unattended an appliance that is working. Don't install or store flammable
materials above or over the stove (curtains, papers, napkins etc.).
Make sure that the valves of the appliances are closed before you open the cylinder or
hose valve.
In case you smell gas or find that the burners have gone out (although appliance models
cut off automatically if the flames go out), turn off the valves of the appliances. Do ventilate
the boat in order to get rid of any residual gas. Find the cause of the problem.
Regularly test the gas system in order to detect any gas leak.
Check all the connections using water and soap or detergent, closing the valves of the
appliances and opening the valve on the cylinder.
If you detect a leak, close the valve of the cylinder and repair before you use it again.
The appliances use the oxygen of the cabin and release combustible gases. Ventilate your
boat when using appliances.
Don't obstruct the air vents and at least leave the door open. Don't use the oven or stove
as back up heaters.
Lock the stove oven when being not used in order to avoid damaging the tubes when
sailing.
Never obstruct the fast access to the components of the gas system. Keep the taps of the
empty cylinders turned off and the cylinders disconnected.
Keep the protection, lids, covers and taps in their places.
Don't use the gas cylinder storage place to store other equipment. Only use the proper
locker to store the gas cylinders.
Regularly check and replace the rubber tubings that link the cylinder to one end of the
circuit and the stove to the other one, depending on the norms and regulations in force in
your country.
ADVICE - RECOMMENDATION
- When changing the cylinder, refit the cap in place on the regulator threaded section
(to avoid corrosion).
- For winter storage instructions and precautions, refer to Chapter 11.
2
S
A
F
E
T
Y