manualshive.com logo in svg
background image

voltage.  Typically the bank should read from about 13.0 to 14.5 volts when being 
charged.  While at rest your voltage will drop as indicated in the figures below.

   

 

All your

 

batteries are charged while underway by the alternator.  The engine and 

house batteries are charged by the battery charger while connected to shore power.  
Ensure that the charger is on.   
 
Voltage             Battery State of Charge 

12.65 volts   

100

%   

 

12.25 volts   

 50 

%

 

12.47 volts   

 75 

%

   

 

11.95 volts                25 

%

 

                                                              11.70 volts   

  0 %   

SANITATION SYSTEM 

 

Marine Toilet  

 

It is imperative that every member of the crew be informed on the proper use of a 
marine head.  The valves, openings, and pumps are small and will clog easily.  If the 
head gets clogged, 

it is your responsibility!

  Always 

pump the head for small children

 

so you can be certain of what is being flushed.  

Note: Never put in paper towels, 

napkins, sanitary products, household T.P., or food into marine heads. 

Use only

 

marine T.P. provided by SHYC

 

To use toilet, move selector switch to the “wet bowl” position.  Pump the handle 3-5 
times to wet the bowl. After using head, pump to remove waste from bowl (approx. 
10 times).  Then return selector back to “dry bowl” position and pump for a few 
times until bowl is dry.   

 

   

 

 
Should the toilet squeak or be a bit sticky to pump, lubricate with a couple of squirts 
of dish soap or salad oil.  Put in bowl and pump 2-3 times to get it to pump and 
leave overnight.  Again, leave in the “dry bowl” position. 
 

Holding Tanks 

 
The forward holding tank holds 18 gal.  It can be emptied either through the deck 
fitting or macerator.  The aft sanitation holding tank holds 15 gallons. This tank can 
be emptied either through the deck fitting or by opening the thru hull fitting located 
at the back of the toilet to allow gravity to empty the tank. Be aware of the rate of 
waste production (about 1 gallon/flush).  If you overfill your tank, you will break a 
hose, clog a vent or burst the tank. 

Which are an indescribable catastrophe

 and a 

very 

expensive fix for you.

  Empty the tanks at least every other day to avoid any 

problems.  

 

 

 
 

WATER SYSTEM 

 

Fresh Water Tank/ Pump/ Hot Water Heater 
 

The fresh water tank(s) holds 100 gallons and are located under the beds. Waste 
water from the sinks and showers drains overboard through various thru-hulls 
usually located under the sinks.  A manifold to switch tanks is located at the back of 
the settee starboard side.

 

 

The water pressure pump is located behind the settee.  Activate the pump by turning 
on the breaker at the DC panel.  If when in use, the pump continues to run, you are 

Содержание 39i










Отзывы: