JDW SG6001B, Инструкция по эксплуатации

Страница: 5 / 10

04
Getting Started
3. When the iron reaches the
desired temperature as
set the indicator light will go
out.
4. The steam output can be
adjusted by sliding the
“steam slide switch” either
forwards or backwards. To
generate more steam move
the slide down.
Caution: Do not use the steam
function on Synthetic Fabric,
Nylon, Synthetic Silk or Silk as it
could damage the garments and/
or the surface of the soleplate.
1.3 Burst of Steam:
This function provides more
steam to remove stubborn
creases.
1. Set the thermostat control
switch to MAX until the
indicator light goes off.
2. Release the steam by
pressing the steam button.
3. Allow the steam to penetrate
through the fabric, and
then release more steam by
pressing this button again,
to obtain the desired result.
Note:
1. Wait 3-5 seconds between
pressing the Steam Button
in order to obtain the best
steaming result.
2. DO NOT HOLD THE IRON
DOWN ON THE FABRIC FOR
MORE THAN 5 SECONDS
3. Ensure the water is filled to
the Max level before using
this function.
1.4 Spraying Methods:
1. Press water spray button,
to release a fine spray of
water on to the fabric before
ironing.