JDS Uniphase SmartClass E1, Справочное руководство

Страница: 34 / 88

Chapter 4 Result commands
About the result commands
20 SmartClass E1 Tester Remote Control Reference Guide
About the result commands
The following results commands act upon the “processed” results within the
measurement application. These are results that have been read from the
underlying ZAP application, synchronized to the second boundary and have
had all the inter-module dependencies and hierarchy applied. These are the
results that appear on the E1 Tester’s menu.
Result subsystem
The results being accessed are being used by the system and because of this
cannot be frozen.
– pr_get
– pr_get_attr
– pr_get_all
– pr_mget_all
– pr_list
The following lists examples of the command set for the RESULT subsystem
within the measurement application.
Querying a result
This command queries the current value of the result. This is a snapshot of the
value.
Command
rc pr_get result_name
Response
2:SCE:cmsend:ack:pr_get value
Example
rc pr_get E1Bert0.BertRx.BitCount
NOTE:
Before you try to get any results, make sure they are applicable. For example,
in e1pulseshape application, if the value of result "E1PulseShape.PulseCap-
ture.PassState" is: no signal, no pulse, not ready, no data, low single or high
single, you will get previous results.