JDS Uniphase OneExpert DSL, Руководство пользователя

Страница: 36 / 120

Chapter 3 Utilities
Specifying system settings
OneExpert DSL User’s Guide
20
22052280, Revision 001 April 2014
In Ethernet TE, you can do a ping, trace route and similar data tests, but cannot change any data
settings.
In DSL, you can perform modem emulate tests with Data mode off.
Ending a remote operation session
To end a remote operation session, either exit the VNC session on the PC/laptop or turn the
OneExpert DSL off and then on again (power cycle).
Enabling Bluetooth
The Bluetooth option allows communication with a mobile device.
To enable Bluetooth
1 From the System Settings menu, select Bluetooth .
2 Touch the box next to Enabled . A check mark appears.
You can now use the OneExpert DSL with a mobile device. See “Using the OneExpert DSL with a
mobile device” on page 73
To disable Bluetooth, touch the box to remove the check mark.
Configuring international settings
The International Setting menu is used to select the language, units of measurement, and other
international settings. There are two ways to select international settings:
– Selecting a preset country. These selections automatically configure the settings as appro-
priate for that country.
– Configuring each setting individually. If you are not in one of the preset countries, or if the
settings aren’t appropriate for your situation, you can configure each setting individually.
These settings are stored when the unit is turned off.
To configure international settings
1 From the System Settings menu, select International Settings .
The International Settings menu appears.
2 Optional. Select Country to select a preset country.
Selecting a specific country will automatically change the settings as appropriate for that
country. For example, selecting Spain will automatically set the language to Spanish, unit of
distance to meters, unit of temperature to celsius, noise filter to CCITT, cable size to millime-
ters, TDR units to m/us, and numerical separator to a comma.
3 Change the settings as appropriate for Language, Measurement System, Temperature Units,
Time Zone, and Cable Terminology.
To change the settings, touch the menu item,
and then select an item from the list.
The international settings are configured.