Appendix
182
CellAdvisor JD720C User's Manual
JDRemote setup
Procedure
1
Launch the JDRemote application.
The Select Model dialog box appears.
2
Select the
720C Series
, and then click the
OK
button.
3
Right-click on the JDRemote window, and then click the
Communication
.
The Communication dialog box appears.
4
Select the
TCP/IP
, and then enter
192
.
168
.
10
.
10
without dots.
5
Click
OK
to finish the communication setup.
6
Right-click on the JDRemote window, and then click the
Connect
.
This enables communication between the instrument and JDRemote.
7
Right-click on the JDRemote window again, and then click the
Start
.
Your JD720C
instrument’s screen appears on the JDRemote screen in real time as shown in
8
Optional.
To adjust the image quality, complete the following steps:
a
Right-click anywhere on the JDRemote.
b
Click the
Quality
.
c
Select the image quality option among
High
,
Medium
, and
Low
.
You can improve refresh rate, if experiencing low-quality signal, by adjusting the image
quality in JDRemote.
Figure 110
JDRemote screen
