Christchurch
P:
03 348 2356
F:
03 348 2376
www.macdonaldindustries.co.nz
05/17
STEP 6:
Carefully refit the case ensuring to hook the top section
of the cover first and then pivot into place. Ensure any
leads do not get jammed between the grill or fan scroll
outlet during refit. Lock cover in place by re inserting
and tightening socket head cap screws with the T25 Torx
drive bit.
The earth screw with serrated washer attached must
be fitted to secure the housing to the metal chassis. This
is a safety requirement and should not be over looked.
Do not over tighten screws.
STEP 7:
Test Unit. Switch on power and check function of unit. Place hand under sensor and unit
should operate continuously and then for a further 5 seconds once hands are removed from
the operating area.
Note:
It is recommended that these units should not be directly/indirectly hosed down.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do not play with the
appliance. All MacDonald Ind disabled compliant products when installed must be in
accordance with AS1428 to ensure the specified product is complying with all washroom
specification requirements.
Auckland (Head Office)
20 Carr Rd, Three Kings
Auckland 1042
P:
09 624 1115
F:
09 624 1110
E:
Wellington
P:
04 569 8033
F:
04 569 8066
