ASSEMBLY
1
Before installing, you will have to decide whether or not you want to cut
the net out of the factory door pocket. If you do, simply cut the netting as
close to the edge as possible and pull it out of the door.
2
Next, place the panel over the frame of the pocket and align the two
circular cutouts in the panel up with the screw cutouts in the door. With
it positioned how you like it, use something to make a mark on the door
through each of the holes. It is easiest to do this with an awl or something
similar so that the screws have a starting point.
3
With the holes marked, start threading the provided screws into each
marked location with a screwdriver and back them back out. This will make
the panel easier to install.
4
Finally, install the panel into the door using the provided screws along with
the provided spacers between the panel and the door.
