JCM UBA Pro RQ Series, Руководство по интеграции

Страница: 21 / 58

P/N 960-000209R_Rev. A © 2019, JAPAN CASH MACHINE CO., LTD.
11
Installation UBA Pro RT/RQ™ Series Banknote Recycler Section 3
Choose a Lock that fits a standard 5/8”, 1-1/8” or
20.5mm hole dimension format (Figure 11). In
addition, when two locks are to be installed, both
locks must be identical.
Unlock Procedure
Make sure lock(s) are installed and rotates in the
correct direction(s).
DIP Switch Configurations
Denomination Acceptance Settings
(DIP Switches at the front)
Table 9 lists the default Front DIP Switches config-
urations for the acceptable denominations.
SW1 and SW2 Configurations
The UBA Pro CPU Circuit Board contains two (2)
DIP Switches that are located adjacent to one
another. The interface and the Recycler option can
be configured by these Switches (Figure 14).
Figure 11 Key Hole Dimension & Cylinder
Length
Figure 11 Key Hole Dimension & Cylinder Length
Ø1
9.1
16.1 mm
1-1/8 in.
5/8 in.
20.5 mm
NOTE: When two locks are installed, they
must rotate in the same direction as
illustrated in Figure 12.
Figure 12 Key Lock Rotation Requirement
Figure 12 Key Lock Rotation Requirement
Unlock Unlock
5/8” or 1-1/8” hole
20.5mm hole
NOTE: When using only one lock, the
remaining blank hole does not provide
access to Cash Box contents. However,
some regulatory authorities may require
installation of a Key Cap.
Figure 13 Key Cap Installation
Figure 13 Key Cap Installation
Use Key Cap
NOTE: There are many lock designs, and
Key Spacer washers may be required for
some lock types. Locks vary greatly in price,
security, keying policies, et cetera. The
customer is responsible for selecting a Lock
with performance that fits the intended
purpose. JCM does not test or endorse any
specific brand of Lock for its security
characteristics.
Table 9 Denomination Acceptance Settings
Switch No. Switch ON/OFF Description
1
ON VEND 1 INHIBIT
OFF VEND 1 ACCEPT
2
ON
VEND 2 INHIBIT
OFF VEND 2 ACCEPT
3
ON
VEND 3 INHIBIT
OFF VEND 3 ACCEPT
4
ON
VEND 4 INHIBIT
OFF VEND 4 ACCEPT
5
ON
VEND 5 INHIBIT
OFF VEND 5 ACCEPT
6
ON
VEND 6 INHIBIT
OFF VEND 6 ACCEPT
7
ON
VEND 7 INHIBIT
OFF VEND 7 ACCEPT
8
OFF
*
*. Not Applicable (N/A). Never Switched to ON.
OFF (Fixed)
NOTE: Front DIP Switch settings may vary
based on Software. Refer to each Country ’s
“ Software Information Sheet” for making the
proper switch settings.
ON
OFF
NOTE: Refer to the UBA Pro RC Series
Banknote Recycler Integration Guide for
the Recycler options.
Figure 14 SW1 and SW2 Switches
Figure 14 SW1 and SW2 Switches
SW1
SW2
Bottom View