19
Inhibit Setting
To perform the inhibit setting, set DIP switch Nos.1, 6 and 7 to ON and then turn on the power to
the TAIKO unit. After the LED flashes white, set DIP Switch No.1 to OFF to enter the setting
mode. Insert the denomination of banknote that you want inhibited into the insertion slot. The
setting is registered if the LED remains lit orange and the banknote is returned. Insert the next
denomination of banknote that you want inhibited.
- The accept/inhibit setting for banknote denominations can be
confirmed with the LED lamp.
After the initial operation is performed, the LED will flash a number
of times equal to the total number of banknote denominations. Blue
indicates an accept setting and yellow means a inhibit setting.
Example: If 5, 10 and 20 Euro notes are set to be accepted and 50
and 100 euro notes to be inhibited, the LED will flash the
corresponding 5 times as follows: blue, blue, blue, yellow
and yellow.
8
7
6
5
4
3
2
1
ON
7-5-1-2. Encryption Code Initializing Setting Mode(This Mode is for only ccTalk
Specification.)
When using ccTalk Communication (Encryption) Mode and the encryption code is unknown,
perform the Encryption Code Initializing Setting to initialize the Encryption Code to the last 6
digits of the TAIKO serial number.
Set DIP switch Nos. 1 to 6 to ON (Set DIP switch Nos. 7 and 8 to OFF) and then supply the power
to the TAIKO unit. Set DIP switch No. 1 to OFF to initialize the encryption code.
Perform the accept/Inhibit Setting of the banknote denomination based on the software for your
country. The default settings are to accept all denomination.
Accept Setting
8
7
6
5
4
3
2
1
ON
7-5-1-1. Denomination Setting Mode(Denomination Setting Mode is available for only
Serial(ID-003)/MDB/Pulse/ccTalk Specification Interface Specification. When using
Parallel(ID-001) Interface Specification, DIP switches should be used in order to configure
the accept/inhibit setting.(Ref. 7-5-2))
To perform the accept setting, set DIP switch Nos.1 and 6 to ON and then turn on the power to the
TAIKO unit. After the LED flashes white, set DIP switch No.1 to OFF to enter the setting mode.
Insert the denomination of banknote that you want accepted into the insertion slot. The setting is
registered if the LED remains lit light blue and the banknote is returned. Insert the next denomina-
tion of banknote that you want to be accepted.
8
7
6
5
4
3
2
1
ON
Содержание TAIKO
