JCM ivizion ld, Эксплуатация и обслуживание

Страница: 66 / 158

P/N 960-100929R_Rev. 7 {EDP #148849} © 2017, JAPAN CASH MACHINE CO., LTD.
4 - 1 0
Section 4 iVIZION® Series Next-Generation Banknote Acceptor Unit Disassembly/Reassembly
Validation Sensor Board
Assembly Removal
To remove the Validation Sensor Board Assembly,
proceed as following:
1. Remove the four (4) Cover Mounting Screws
(Figure 4-36 a
1
to a
4
) located on the base side of
the Validation Unit, and remove the
iVIZION
Head Cover “A” (Figure 4-36 b ) off the Valida-
tion Assembly.
2. Remove the two (2) mounting Screws (Figure 4-
37 a
1
& a
2
) and take Grounding Plate “A” (Figure
4-37 b ) off the Validation Unit.
3. Remove the two (2) screws (Figure 4-37 c
1
& c
2
)
securing the Validation Sensor Assembly Board.
4. Unplug the two (2) FPC Cables (Figure 4-37 d
1
&
d
2
) and the two (2) FFC Cables (Figure 4-37 e
1
&
e
2
) from the Validation Sensor Assembly Board.
5. Take the Validation Sensor Board Assembly (Fig-
ure 4-37 f ) off the Validation Unit.
Validation Sensor FPC Cable
Removal
To remove the Validation Sensor FPC Cables,
proceed as follows:
1. Remove the two (2) Validation Sensor FPC
Cables (Figure 4-38 a
1
& a
2
) from the
Validation Unit.
Figure 4-36 iVIZION Head Cover A Removal
Figure 4-36 iVIZION Head Cover A Removal
a
1
a
2
a
3
a
4
b
Figure 4-37 Validation Sensor Board Assembly
Removal
Figure 4-37 Validation Sensor Board Assembly
Removal
a
1
a
2
b
c
1
c
2
d
1
e
1
e
2
d
2
f
Figure 4-38 Validation Sensor FPC Removal
Figure 4-38 Validation Sensor FPC Removal
a
1
a
2
Dashed Line
for Fold Up
Solid Line
for Fold Down
NOTE: Carefully observe the Up and
Down Fold Line indications shown by
the two (2) Cyan Arrows in Figure 4-
38, and DO NOT unfold them in an
opposite direction!
NOTE: When installing new FPCs,
fold-up along the Solid Lines and
fold-down along the Dashed Lines
before setting them in place. Once an
FPC is folded, DO NOT unfold it back
again or fold in the opposite direction.
NOTE: When the Unit is
reassembled, the FPCs should be
reinstalled as illustrated by the Blue
paths shown in Figure 4-39.
Figure 4-39 Validation Sensor FPC
Reassembly
Figure 4-39 Validation Sensor FPC Reassembly