December, 2006
© 2006, JCM American, Corporation
6
2 3
Lecture Notes
Lecture Notes
UNIT INSTALLATION
V
ENDING
M
ACHINE
I
NSTALLATION
To properly install an A-66 into a Vending Machine perform the following
steps:
1. Disconnect AC power to the Vending Machine.
2. Lift up on the White colored locking lever located on the top right side of the
A-66 Coin Changer chassis.
3. Grasp the Validator unit at the top and tilt it out forward about 45 degrees until
the two lower guide pins located at the bottom of the unit raise up midway from
their locked position. The validator may now be pulled out of the A-66 assembly.
4. Disconnect the ribbon cable from the rear of the unit and temporarily set the
Validator unit aside.
5. Mount the A-66 Coin Changer into the Vending Machine using the three (3)
screw holes located on the back inside of the A-66 chassis.
6. Tighten the mounting screws, and reinsert the Validator Unit back into the A-66
chassis by inserting the lower guide pins in first, then pushing forward until the
Validator 'clicks' into place.
7. Reconnect all internal power and interconnect cables as required.
8. Restore AC power to the Vending Machine.
NOTE: Two of the holes are located at the top of the chassis while the third hole is
located about 4 inches lower on the left side back wall (See Figure 2).
3
Another hole
at bottom
Upper Mounting Holes
2
1
Pull
Out
Lift up
4
Figure 2
Mounting Hole Locations
NOTE: Don't forget to reconnect the ribbon cable at the rear of the Validator Unit.
P
ALM
A66US (C
ONTINUED
)
13.From the
‘Settings’
Screen again, select
‘Other Settings’
. This screen is
depicted in Figure 28 and presents the following data:
•
Smallest Coin Value:
This is a reference value for all coins currently
programmed. All coin values requiring acceptance must be a multiple of the
smallest coin value.
•
Telephone Code and Currency Code:
These codes are used together to set
the Vending Machine’s language and currency type.
• MDB Feature Level:
–
Level 2:
The Vending Machine Controller controls all payout functions.
–
Level 3:
The Coin Changer controls all payout functions.
14.On the Main Menu Screen, click on the
‘Service’
Screen Button (See Figure 29
a). The Service Sub-menu shown in Figure 30 on page 24 consists of four (4)
choices (i.e.,
Payout Set, Filling Levels, Teach Token,
and
Convert Currency
).
15.Select
‘Payout Set’
and the screen is shown in Figure 31 on page 24 will
appear. The user may test the payout motors by selecting individual coin tubes
(
L, ML, MR, R
). The
‘Counter’
value indicates the number of coins in each
tube. This value may be edited if incorrect by clicking on the
‘Edit counter’
Screen Button.
Figure 28
Other Settings Screen
Figure 27
Recycler Screen
