© 2013, JCM American, Corporation
1 9
July, 2013
Lecture Notes
N
ON
-PC C
ALIBRATION
P
ROCEDURES
(C
ONTINUED
)
8. Set the White Reference Paper in place.
9. Set DS 2, Switch #2 to ON to begin the Validation Sensor Adjustment.
10.The White Reference Paper Adjustment is complete when the Front Panel LED
blinks at a
Blue
Color Rate.
11.Remove the White Reference Paper.
12.Set the Black Reference Paper.
13.Set DS 2, Switch #3 to ON to begin the Validation Sensor's Adjustment with the
Black Reference Paper.
14.The Black Reference Paper adjustment is complete when the Front Panel LED
blinks at a
Purple
Color Rate.
15.Remove the Black Reference Paper.
16.Set DS 2, Switch #4 to ON to re-perform the Validation Sensor's Non-paper
adjustment.
17.The Validation Sensor's Non-paper adjustment is complete when the Front Panel
LED blinks at a
Green
Color Rate.
18.Set DS 2, Switch #5 to ON to begin the Edge Sensor's Non-paper Adjustment.
19.The Edge Sensor's Non-paper Adjustment is complete when the front Panel
LED blinks at a
Yellow
Color Rate.
20.Set DS 2, Switches #1, #2, #3, #4, & #5 OFF in order to write these adjustments
into the VEGA's EEPROM Memory.
21.The adjustments are successfully written into the Memory when the Front Panel
LED blinks at a
Green
Color Rate.
22.Remove power from the VEGA Unit.
Table 9
Sensor Adjustment Error Conditions
LED Color
Blink Sequence
Error Indication
RED
1 Blink
The Entrance Sensor adjustment has failed.
2 Blinks
The Entrance Sensor adjustment using White Reference Paper
has failed.
3 Blinks
The Validation Sensor adjustment using Black Reference Paper
has failed.
4 Blinks
The Validation Sensor’s Non-Paper adjustment has failed.
5 Blinks
The Edge Sensor adjustment has failed.
6 Blinks
The EEPROM data writing process has failed.
NOTE: If the adjustment of any Sensor fails, the Front Panel LED will blink
Red
.
See Table 9 for Error Indications.