JCM GLOBAL UBA Pro Series, Руководство по эксплуатации и обслуживанию

Страница: 63 / 132

P/N 960-000211R_Rev. A © 2020, JAPAN CASH MACHINE CO., LTD.
4 - 5
Disassembly/Reassembly UBA™ Pro Series Universal Banknote Acceptor Section 4
6. Unplug the Motor Harness (Figure 4-19 a ), and
feed the Harness in through the hole on the side
of the Unit as illustrated.
7. Remove the Centering Motor Harness Assy. (Fig-
ure 4-19 b ).
Entrance Motor Harness Assy.
Removal
To remove the Entrance Motor Harness Assy., pro-
ceed as follows:
1. Feed the Harness (Figure 4-20 a ) in though the
hole on the side of the Unit as illustrated by the
Arrow.
2. Remove the Entrance Motor Harness Assy. (Fig-
ure 4-20 b ).
Centering HP Board Removal
To remove the Centering HP Board, proceed as fol-
lows:
1. Remove the Middle Bracket Assy. (Figure 4-21
a ).
2. Remove the single (1) Screw (Figure 4-22 a ).
3. Remove and take the Centering HP Board (Fig-
ure 4-23 a ) out through the side of the Unit as
illustrated by the Arrow.
Figure 4-19 Centering Motor Harness Assy.
Removal 4
a
b
Connector
Figure 4-19 Centering Motor Harness Assy.
Removal 4
Figure 4-20 Entrance Motor Harness Assy.
Removal
a
b
Figure 4-20 Entrance Motor Harness Assy.
Removal
Figure 4-21 Centering HP Board Removal 1
a
Figure 4-21 Centering HP Board Removal 1
NOTE: For the reassembly, ensure that
Middle Bracket Assy. is firmly installed in
place.
NOTE: For the reassembly, ensure that
Centering Guide R and L are symmetrically
positioned at the exact same distance from
the center.
Figure 4-22 Centering HP Board Removal 2
a
Figure 4-22 Centering HP Board Removal 2
Figure 4-23 Centering HP Board Removal 3
a
Figure 4-23 Centering HP Board Removal 3