JCM GLOBAL UBA Pro Series, Руководство по эксплуатации и обслуживанию

Страница: 44 / 132

P/N 960-000211R_Rev. A © 2020, JAPAN CASH MACHINE CO., LTD.
2 - 1 6
Section 2 UBA™ Pro Series Universal Banknote Acceptor Installation
Preventive Maintenance
Collecting Banknotes
To collect Cash Box deposited Banknotes, perform
the following steps:
1. Pull the Cash Box Handle to separate the Cash
Box from the Frame Housing.
2. Press thumb on the Acceptor Head while pulling
the Cash Box Handle forward to obtain better
leverage during Cash Box extraction.
3. When a lock is installed on a Cash Box, use the
appropriate key to unlock the Cash Box first.
4. Open the Cash Box Door and remove the
Banknotes as illustrated in Figure 2-12.
Clearing a Banknote Jam
To remove a jammed Banknote located inside the
Banknote Acceptor, proceed as follows:
1. Lift up on the Upper Guide Access Lever to open
the UBA Pro’s Cover (Figure 2-13 a ).
2. Remove the jammed Banknote (Figure 2-13 b
1
).
3. Remove the UBA Pro Unit (Figure 2-13 c ) from
the Frame (Figure 2-13 d ).
4. Remove any jammed Banknote found in the
Transport or Cash Box area (Figure 2-13 b
2
).
5. If the Banknote jam location is not evident, pull
on the Cash Box Handle to remove it from the
Frame (Figure 2-13 e ).
6. Remove any jammed Banknote found there (Fig-
ure 2-13 b
3
& b
4
).
Opening the Centering Mechanism
If a Banknote jam occurs and the Centering Mech-
anism is closed, the Cover will not open. To unjam
the Unit when this occurs, recycle power to the
Unit and allow it to reset.
Figure 2-12 Collecting Banknotes
Figure 2-12 Collecting Banknotes
Figure 2-13 Clearing a Banknote Jam
Figure 2-13 Clearing a Banknote Jam
a
b
1
b
2
b
3
b
4
c
d
e
NOTE: If recycling the power fails to clear a
Banknote jam, use a 5.5mm Hex Nut Driver
to rotate the Centering Guides out of the
way, then open the Top Cover and remove
the jam (Figure 2-14).
Figure 2-14 Opening Centering Mechanism
Figure 2-14 Opening Centering Mechanism
5.5mm Hex Nut Driver
Centering Guide Shaft