JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
F
G
H
4. VARIABLE SPEED
CONTROL (See F)
With the variable speed control (3),
the required speed can be selected
(also while running). The required
speed is dependent on the material
and is to be determined by a
practical trial.
If your power tool becomes too hot,
especially when used at low speed,
set the speed to maximum and run
with no load for 2-3 minutes to cool
the motor. Avoid prolonged usage at
very low speed.
5. HAND GRIP AREA
(See G, H)
Your sander is designed to be held
either around the main housings,
or by the top of the main housing.
When sanding for a long period at
one time, it is recommended you
periodically alternate between the
two holding positions.
6. SANDING SURFACES
Place the machine with the complete
Sand paper on the surface to be
worked. Ensure uniform sanding
pressure. Less sanding pressure
increases the sanding capacity
and protects the machine and the
sanding tool. The removal capacity
and the sanding pattern are
determined mainly by the selection
of the Sand paper (grain size), the
speed of the sanding plate and the