jcb JCB-MC300, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
MOUNTING / CHANGING
THE MESH SANDING
SHEET(See D,E)
2a) Flip the tool-less blade change
lever (1) forward to the open
position to loosen the flange (7).
Remove plunge cut saw blade.
Insert the sanding base (12) onto
the accessory interface (6), then
(if necessary, re-insert the flange)
press down the flange with finger to
keep the blade temporarily secure.
Flip lever (1) back down to seated
position to secure accessory.
2b) Place the mesh sanding sheet
directly onto the base plate and
press the sheet onto the pad. Firmly
press the oscillating tool with the
installed sanding sheet against a flat
surface and briefly switch the power
tool on. This provides for good
adhesion and prevents premature
wear. If one point has become worn
after use, pull off the sanding sheet,
turn it 120°, and re-install.
2. OPERATING THE ON/
OFF SWITCH
—— Switching the power tool ON:
Slide switch forward.
—— Switching the power tool OFF:
Slide switch backward.
3. USING THE VARIABLE
SPEED DIAL
Select oscillation frequency (speed)
while the motor is running.
A
A
A
2
D
B
E
2
3
I
I
2
I
I
K
N
N
G
G
C
K